Min Offset X - Controls the minimum movement, so should normally be set to 0 to randomly move between 0 and the value in 'Max Offset X'. Max Offset X - Controls how much each board can move in the X direction, usually the length direction., it is restricted to not overlap other boards, if you don't care about that read about 'Max Overlap' below. Spread - Controls the distribution between Max and Min, if the spread value is low then only a few boards will be rotated with the maximum value, if it's 0,5 the rotation is evenly distributed, and if it's high more boards will be rotated with the Max value. Min Rotation - Controls the minimum rotation, so should normally be set to 0 to randomly rotate between 0 and the value in 'Max Rotation'. Max Rotation - Controls how much each board can rotate around itself, it is restricted to not overlap other boards, if you don't care about that read about 'Max Overlap' below. Hexagon, Radius - Controls the size of one hexagon tile, the radius is the size of the circumscribed circle.

Herringbone, Parallel Boards - Controls how many boards there should be side by side.Ĭhevron, Angle - Controls the angle of the boards, don't use too high angle, it might create A LOT of boards.īasket Weave, Sub Boards - Controls how many boards there should be inside each square. Settings specific to certain types of floors: Outline - Controls the width of the bevel, by default it's locked to the height in order to create a 45 degree bevel. Row Offset % - Controls how much each row of boards should be offset.Įxtrude H - Controls the height of the floor.īevel H - Controls the height have the bevel along the edge of the board. Grout Wid - Control the width of the grout in the width direction. Grout Len - Controls the width of the grout in the length direction. Spread - Controls the distribution if there is variable width, for details read above. Min Width - Controls the minimum length a board can be. Max Width - Controls the maximum width a board can be. Spread - If you have boards with variable length the 'Spread' setting will control the distribution between the two sizes, 0,5 the length is evenly distributed, a low Spread value creates a lot of long boards and only a few short ones, a high spread creates a lot of short boards and only a few long ones. Min Length - Controls the minimum length a board can be. Max Length - Controls the maximum length a board can be.

Floor Pattern - If you have the full version you can switch between the types of patterns in the '''Floor Pattern' Drop down menu.

3ds max student version